Stratis 2.0.0 Release Notes

mulhern, Stratis Team

Stratis 2.0 is a significant update for both the daemon and the CLI. The changes to the daemon are covered first, followed by the changes to the CLI.

stratisd 2.0.0

This release makes the D-Bus API more robust, reliable, predictable, and extensible. There are several significant changes:

• The set of D-Bus properties has been reduced to a core set of fundamental and stable properties. Other filesystem, pool, or block devices properties are now obtainable via methods in the FetchProperties interface. This change increases the robustness of the D-Bus interface to failures occurring in any particular pool, filesystem, or block device, and decreases the computational cost of most operations requested by the Stratis CLI. Several properties, formerly returned as D-Bus properties, are now unavailable by means of the D-Bus. In every case, the reason for removing the property was that it did not represent a well-defined value. See project issue 52 for further details.

• All D-Bus method calls are idempotent. This should make writing scripts using the D-Bus API much simpler and make reasoning about the behavior of the engine more straightforward. Henceforth, we will treat as a bug any non-idempotent behavior in the D-Bus API. See project issue 51 for further details.

• All D-Bus size values are now returned in bytes. Again, this should make writing scripts against the D-Bus more straightforward, since it will be unnecessary for the script writer to change their interpretation of the number returned on the D-Bus depending on the value that it represents. See stratisd issue 1243 for further details.

Future enhancements to the D-Bus API will be implemented by means of additional versioned interfaces.

Please consult the D-Bus API Reference for the precise D-Bus specification.

stratis-cli 2.0.0

This release requires stratisd 2.0.0. The user will observe the following significant improvements:

• The CLI is significantly more robust. Previously, there was a category of error conditions in pools, filesystems, and block devices that would make the CLI virtually unusable; this problem has now been entirely resolved. See project issue 52 for further details.

• The CLI now reports errors consistently in conditions where a human user would generally expect an error to be reported. Previously, many commands in the CLI were idempotent, to facilitate scripting. Now there is a clear distinction between the CLI behavior and the stratisd D-Bus API behavior: the CLI behavior is designed strictly according to the expectations of a human user, the stratisd D-Bus API is the programmable interface. See project issue 51 for further details.

As always, anyone wishing to implement a program that uses Stratis for storage management is strongly advised to make use of the stratisd D-Bus API rather than the CLI.